Edge Regulatory Text

Regulatory Text For BC510 User Manual

European Regulatory Text

EUROPE:
Product: BC510 Edge Relay 1
Model: BC510

Declaration of conformity:
This equipment is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU (RED) and 2011/65/EU (RoHS).

Standards Applied:
EN 300 328 V2.1.1
draft EN 301 489-1 V2.1.1; draft EN 301 489-17 V3.1.1
EN 62311 2008
EN 62368-1: 2014

BT parameters: Receiver category 3
Frequency band: 2402 – 2480 MHz
Number of channels: 40
RF output power: 4.81 dBm EIRP
Antenna: External, Rod antenna, 2 dBi

Wi-Fi parameters: Receiver category 1
Frequency band: 11bgn(HT20): 2412 – 2472 MHz; 11n(HT40): 2422-2462 MHz
Number of channels: 11bgn(HT20): 13 ;11n(HT40): 9
RF output power: 16.95 dBm EIRP
Antenna: PCB antenna, 2.57 dBi

Max. operating temperature: 45 deg C.

Manufacturer: BlueCats Incorporated
301-A Chicon St.
Austin, Texas
United States, 78702

ISED Canada regulatory information:


This device complies with Industry Canada licence-exempt RSS standard(s). 
Operation is subject to the following two conditions:


(1) This device may not cause interference and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.


Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence.L’exploitation est autorisée aux deux conditions suivantes :


(1) l’appareil ne doit pas produire de brouillage, et


(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d’en compromettre le fonctionnement.


This radio transmitter, IC Certification Number 21338-BC510, 
has been approved by Industry Canada to operate with the antenna types listed below (2.57dBi for WiFi and 2dBi for BLE) with the
maximum permissible gain and required antenna impedance for each antenna type indicated.
Antenna types not included in this list, having a gain greater than the maximum gain indicated for
that type, are strictly prohibited for use with this device.


Le présent émetteur radio de certificiation IC 21338-BC510 a été approuvé par Industrie Canada pour fonctionner avec les types d’antenne énumérés ci-dessous et ayant un gain admissible maximal et l’impédance requise pour chaque type d’antenne(WiFi - 2.57dBi/BLE - 2dBi). Les types d’antenne non inclus dans cette liste, ou dont le gain est supérieur au gain maximal indiqué, sont strictement interdits pour l’exploitation de l’émetteur.


This equipment should be installed and operated with a minimum distance of 20 cm between the
radiator and your body.


Cet équipement doit être installé et utilisé à une distance minimale de 20 cm entre le radiateur et
votre corps.

FCC Warning

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two Conditions

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired operation.
Note 1:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Note 2:
1.
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
2.
RF exposure: The minimum separation distance between antenna and body shall be at least 20 cm.